Beech sawhorse – Reinforced spreader for cutting and assembly support

The beech sawhorse is a work support designed for cutting, assembly and handling operations in the workshop or on site. Its wooden structure incorporates a reinforced spreader that stabilises the opening and limits movement during use. With a 50 × 25 mm section and 80 × 80 cm dimensions, it provides a suitable base for temporary workbenches, boards, panels and timber pieces. The stated maximum load is 120 kg. This sawhorse is sold individually. To extend its service life, it is recommended to regularly check the pivot points and protect the wood according to the level of exposure to moisture.

Main characteristics

Key points

• Beech structure for workshop and site use.
• Reinforced spreader limiting variations in opening during use.
• 80 × 80 cm format suitable for boards, panels and temporary supports.
• 50 × 25 mm section for a regular geometry of the uprights.
• Stated maximum load: 120 kg.
• Sold individually.

Installation advice

1. Unfold the sawhorse on a flat, stable surface.
2. Check the locking of the spreader and ensure it is fully open before loading.
3. Position the sawhorse so that the load is distributed across the centre of the top rail.
4. For a workbench, use two sawhorses and check alignment before laying the board.
5. Avoid point loads in cantilever and observe the maximum load (120 kg).

Maintenance and protection

Dust the wood regularly and check the metal components (spreader, axles, fixings). If used in a damp environment or stored in an unheated space, apply a suitable protective treatment (oil, varnish or wood stain depending on use). Store the sawhorse flat, away from water splashes, to limit dimensional variations.

FAQ – Beech sawhorse with reinforced spreader

How to set up this beech sawhorse?

Unfold the sawhorse on a flat surface, check the locking of the reinforced spreader, then distribute the load across the centre of the top rail. Use two sawhorses to support a board.

What is the service life of a beech sawhorse?

Service life depends on conditions of use (moisture, impact, overloading) and maintenance. Dry storage and wood protection extend the lifespan, especially on site.

Is this sawhorse suitable for outdoor use?

It can be used occasionally outdoors if the wood is protected and the sawhorse is not stored in damp conditions. For regular outdoor use, a film-forming treatment or suitable finish is recommended.

What is the best sawhorse for creating a temporary workbench?

An 80 × 80 cm sawhorse with a reinforced spreader is suitable for supporting a board. It is recommended to use two sawhorses and to choose a rigid board with a distributed load.

Why choose this wooden sawhorse over a metal sawhorse?

A wooden sawhorse can be easier to drill or screw into for temporary assemblies (stops, shims, jigs). The choice depends on the need: wood for quick adaptations, metal for highly exposed environments or specific intensive use.

View finishes and wood protection products

Explore workshop accessories and consumables