Straight Outdoor Staircase Flex Grid Zinc - 6 to 14 Steps

Straight outdoor metal staircase Flex Grid Zinc - 6 to 14 steps

This straight outdoor staircase in galvanised and black powder-coated steel can cover finished floor-to-floor heights of up to 345 cm. It is installed to provide access to a raised terrace, an upper-level entrance or any outdoor layout requiring direct access from the garden.

The structure combines galvanisation, which protects the steel against corrosion, with a black powder coating that further enhances this protection whilst giving the staircase a uniform appearance. The steps are made from anti-slip grating: their open mesh allows water, snow and dirt to pass through, reducing slippery surfaces in wet or icy conditions.

The staircase height is adjusted by modifying the angle of inclination, without any cutting or additional parts. It is available in four sizes: 6, 10, 12 or 14 steps, covering finished floor-to-floor heights of 91.5 cm to 345.2 cm depending on the number of steps selected and the inclination chosen.

Main characteristics

Height ranges and footprints according to number of steps

Each size can be adjusted to several effective step counts. The steeper the inclination, the greater the finished floor-to-floor height covered and the less floor space the staircase occupies: the two values move in opposite directions.

Key points

• ✓ Anti-corrosion protection: galvanised steel ensuring a long service life outdoors
• ✓ Enhanced finish: black powder coating, additional protection against the elements
• ✓ Safe passage: anti-slip grating steps, usable in icy, wet or dirty conditions
• ✓ Effective drainage: open mesh steps allowing water, snow and dirt to pass through
• ✓ Simplified adjustment: height adjustment by modifying the angle of inclination, without any cutting
• ✓ Modular choice: 4 sizes available (6, 10, 12 or 14 steps) for finished floor-to-floor heights of up to 345 cm
• ✓ Comfortable passage: clear width of 710 mm and balustrade at 1050 mm height

Installation advice

Preparation: check that the slab or decking opening has a minimum clearance of 2000 x 860 mm. The starting surface (concrete slab, terrace, pad) must be flat, stable and capable of bearing the load of the staircase and its users. Ensure a suitable receiving surface at the top of the staircase appropriate to the target height.

Adjustment: the effective number of steps and the angle of inclination determine the finished floor-to-floor height covered, which ranges depending on the model between 91.5 cm and 345.2 cm. Adjust the inclination before final fixing to achieve the desired riser height, between 180 and 230 mm.

Fixing: secure the stringers at the base and top of the staircase with fasteners suitable for the substrate (not supplied unless otherwise stated on the product sheet). Assembly requires a minimum of two people given the weight and size of the structure.

Finishing: check the horizontality of each step after fixing and the correct locking of the balustrade, supplied at a height of 1050 mm.

Maintenance and protection

The combination of galvanisation and powder coating significantly reduces the maintenance required. Clean the staircase 1 to 2 times per year with clean water and a mild soap, using a soft brush, paying particular attention to the grating where leaves and deposits can accumulate. Avoid abrasive products or solvents, which can damage the powder-coated finish.

In the event of a chip or deep scratch on the powder coating, a localised touch-up with a compatible anti-rust paint prevents corrosion from developing on the exposed steel. An annual check of the tightness of the fixings is recommended, particularly after periods of frost.

Data to be confirmed according to product specifications: contractual warranty period applicable to the product.

WoodUp Advice

Before confirming the size, measure the exact finished floor-to-floor height between the starting point and the arrival point: a difference of a few centimetres is enough to shift from one size to another, as each model covers a specific range (for example 91.5 to 161.2 cm for the Flex 6). What to know before buying: also check the available footprint at the base of the staircase, which ranges from 91 cm to 340 cm depending on the size and inclination chosen, as well as the nature of the receiving surface at the top of the staircase.

Frequently asked questions